How to clean the slurry pump?

The following are general steps for cleaning the slurry pump:

1. Drain residual mud: 

Empty as much mud as possible from the pump.

2. Disassemble parts: 

Disassemble removable parts according to the pump's instructions.

3. Remove solid impurities: 

Remove solid impurities in the pump and on the parts with a brush or other tools.

4. Clean the pump body: 

Flush the inside of the pump body with clean water to remove any residual mud.

5. Clean parts: 

Clean disassembled parts to remove dirt and impurities.

6. Inspect parts: 

Inspect parts for wear or damage and repair or replace if necessary.

7. Reassemble: 

Assemble the cleaned parts back into the pump body in the correct order.

8. Test pump operation: 

Before putting the pump back into service, test it to ensure proper operation.

During the cleaning process, it is also important to pay attention to the following points:
1. Wear appropriate protective equipment such as gloves and goggles.
2. avoid using highly corrosive cleaning agents that may damage pump components.
3. ensure that all parts are thoroughly cleaned to avoid leaving dirt and impurities.
4. follow the pump instruction manual to ensure proper cleaning and maintenance.
5. Perform periodic cleaning to keep the pump in good operating condition.
6. after cleaning, lubricate and maintain the pump to extend its service life.

ZJ Single Grade Slurry Pump PD300ZJ-I-A56