How to start the mud pump?

The general steps to start the Mud Pump are as follows:

1. Check preparation:

Ensure that all parts of the mud pump are intact, the lubricant is sufficient, and the power connection is normal.

2. Open the inlet and outlet valves:

Ensure that the mud can go in and out smoothly.

3. Start the power supply:

According to the type of mud pump, start the corresponding power source.

4. Check the running status:

Observe whether the sound, vibration and temperature of the pump are normal.

5. Adjust the parameters:

Adjust the flow rate, pressure and other parameters of the mud pump as needed.

6. Pay attention to the mud condition:

Ensure that the concentration, viscosity, etc. of the mud meets the requirements.

7. Monitor pressure changes:

Avoid excessive high or low pressure.

8. Check seals:

Ensure that there is no leakage.

9. Pay attention to abnormal conditions:

If there is abnormal noise, overheating, etc., stop the machine in time to check.

10. Regular maintenance:

Carry out maintenance according to the regulations to prolong the life of the mud pump.
Before starting the mud pump, please be sure to read the relevant operation manual and safety regulations carefully.

12/10G-G Gravel sand pump for Dredging